Valor-auto-companion-inc Valor Legend Ultra 837 AN Manuel d'utilisateur télécharger pdf (Page 3)

Safety Upgrade Instructions

Page 3

Figure 7. Fitting the locating

racket.

Figure 6. Removal of Bushing.

Figure 5. Removal of Screw from

locatin

bracket.

2. Removal of bushing from ignition bar

For models fitted with a locating bracket (See figure 5)

1. Remove the self-tapping screw from the

ignition bar locating bracket (See figure 5).

2. Place a suitable flat instrument on the

underside of the bushing and lift the bushing

clear of the mounting bracket (see figure 6).

3. Pull the ignition bar forward and clear of the

mounting bracket.

4. Remove bushing from ignition bar by sliding

up around bend and off bar. If bushing is too

tight to slide off, cut off bushing with a utility

knife.

5. With the bushing removed, push the ignition

bar back into the mounting bracket.

6. Replace the locating bracket and secure using

the self-tapping screw removed previously.

For models NOT fitted with a locating bracket

(See figure 5)

7. Place a suitable flat instrument on the

underside of the bushing and lift the bushing

clear of the mounting bracket (see figure 6).

8. Pull the ignition bar forward and clear of the

mounting bracket.

9. Remove bushing from ignition bar by sliding

up around bend and off bar. If bushing is too

tight to slide off, cut off bushing with a

utility knife.

10. With the bushing removed, push the ignition

bar back into the mounting bracket.

11. Position the locating bracket with its sides in

line with those of the mounting bracket (See

figure 7). Mark the position of the hole.

12. Remove the bracket and drill a 3.5mm (1/8

in) hole

13. Reposition the location bracket

and secure using a self-tapping screw.

1 2 3 4 5 6 7 8 ... 11 12

Commentaires sur ces manuels

Pas de commentaire

Valor-auto-companion-inc Valor Legend Ultra 837 AN Manuel d'utilisateur Page 3

Commentaires sur ces manuels